diff --git a/examples/TemperatureAlert/TemperatureAlert.ino b/examples/TemperatureAlert/TemperatureAlert.ino
new file mode 100644
index 0000000..beb44fa
--- /dev/null
+++ b/examples/TemperatureAlert/TemperatureAlert.ino
@@ -0,0 +1,48 @@
+/*
+  HTS221 - Temperature Alert
+  This example reads data from the on-board HTS221 sensor of the
+  Nano 33 BLE Sense. If the temperature increases above a certain limit, it turns the buzzer on.
+  The circuit:
+  - Arduino Nano 33 BLE Sense
+  - Active buzzer module connected to pin 9 and GND
+
+  written by K.Abhijeet
+  This example code is in the public domain
+*/
+
+#include <Arduino_HTS221.h>
+
+float tempLimit = 37;  // set your temperature limit in °C
+
+void setup() {
+  Serial.begin(9600);
+  while (!Serial);
+
+  pinMode(9, OUTPUT);
+
+  if (!HTS.begin()) {
+    Serial.println("Failed to initialize humidity temperature sensor!");
+    while (1);
+  }
+}
+
+void loop() {
+
+  float temperature = HTS.readTemperature();  // read the sensor value
+
+  Serial.print("Temperature = ");  // print the sensor value
+  Serial.print(temperature);
+  Serial.println(" °C");
+
+  if (temperature > tempLimit)
+  {
+    digitalWrite(9, HIGH);
+    delay(500);
+    digitalWrite(9, LOW);
+    delay(500);
+  }
+  else
+  {
+    delay(2000); // wait a while before displaying the next reading If the temperature is below the limit
+  }
+}