kernel: Bump to 4.9.60

kernel: ARM: dts: Add fake CTS signal to pi3-miniuart-bt
See: https://www.raspberrypi.org/forums/viewtopic.php?f=107&t=138223&start=100#p1228339

kernel: w1: add support for DS2438 Smart Battery Monitor
See: raspberrypi/linux#2246

firmware: image_encode and JPEG codec fixes
See: raspberrypi/userland#435

Author: popcornmix

boot/fixup.dat

@@ -745,8 +745,8 @@ Name:   i2c-sensor
 Info:   Adds support for a number of I2C barometric pressure and temperature
         sensors on i2c_arm
 Load:   dtoverlay=i2c-sensor,<param>=<val>
-Params: addr                    Set the address for the BME280, BMP280, TMP102
-                                or LM75
+Params: addr                    Set the address for the BME280, BMP280, TMP102,
+                                HDC100X or LM75
 
         bme280                  Select the Bosch Sensortronic BME280
                                 Valid addresses 0x76-0x77, default 0x76
@@ -771,6 +771,15 @@ Params: addr                    Set the address for the BME280, BMP280, TMP102
         tmp102                  Select the Texas Instruments TMP102 temp sensor
                                 Valid addresses 0x48-0x4b, default 0x48
 
+        hdc100x                 Select the Texas Instruments HDC100x temp sensor
+                                Valid addresses 0x40-0x43, default 0x40
+
+        tsl4531                 Select the AMS TSL4531 digital ambient light
+                                sensor
+
+        veml6070                Select the Vishay VEML6070 ultraviolet light
+                                sensor
+
 
 Name:   i2c0-bcm2708
 Info:   Enable the i2c_bcm2708 driver for the i2c0 bus. Not all pin combinations